2002 Toyota Tundra - 2002 Tundra Remote Keyless Entry Programming (3 pages)
Download 2002 Tundra Remote Keyless Entry Programming
Manual Description
Programmed to be operated by as many as 4 REMOTE CONTROLS, rEMOTE CONTROL, you must connect the ignition switch connector Remote Keyless, entry wire harness to the vehicle's ignition switch and access the RS3000 (RKE) ECU, switch connector (Page 6) and to locate RKE ECU.
To program (add) a REMOTE CONTROL system, insert the key into the ignition switch, and turn it ON”, press and hold the ECU's PROGRAMMINGSWITCH 3 seconds, –YOU MUST PERFORM THE NEXT STEP WITHIN 5 SECONDS–.
Press and release a REMOTE CONTROL's top bottom button, the factory preset operation is for the top button on both original REMOTE CONTROLS, to operate the RKE system; the bottom button is not programmed, erasure of a REMOTE CONTROL's code, we recommend that you program all.
* Either button on the REMOTE CONTROL can be programmed operate RKE, to erase all REMOTE CONTROL codes system, insert key into the ignition switch, and turn it ON”, press and hold the ECU's PROGRAMMINGSWITCH for over 2 seconds again.
The PIEZO CHIRPER” chirps 3 times, and the exterior lights flash 3 times, rEMOTE CONTROL is programmed, the system will not work with any REMOTE CONTROL, to activate VALET MODE (disable security functions), insert the key into the ignition switch, and turn it to ON” ( not ACC”).
Using REMOTE CONTROL, press and hold both buttons (at the same time) over 2, –YOU MUST PERFORM THE NEXT STEPS WITHIN 30 SECONDS–, steps, the previous operation mode will remain unchanged, nOTE: This procedure is not necessary if the vehicle is equipped with RS3000 Plus.
Manual Description
Programmed to be operated by as many as 4 REMOTE CONTROLS, rEMOTE CONTROL, you must connect the ignition switch connector Remote Keyless, entry wire harness to the vehicle's ignition switch and access the RS3000 (RKE) ECU, switch connector (Page 6) and to locate RKE ECU.
To program (add) a REMOTE CONTROL system, insert the key into the ignition switch, and turn it ON”, press and hold the ECU's PROGRAMMINGSWITCH 3 seconds, –YOU MUST PERFORM THE NEXT STEP WITHIN 5 SECONDS–.
Press and release a REMOTE CONTROL's top bottom button, the factory preset operation is for the top button on both original REMOTE CONTROLS, to operate the RKE system; the bottom button is not programmed, erasure of a REMOTE CONTROL's code, we recommend that you program all.
* Either button on the REMOTE CONTROL can be programmed operate RKE, to erase all REMOTE CONTROL codes system, insert key into the ignition switch, and turn it ON”, press and hold the ECU's PROGRAMMINGSWITCH for over 2 seconds again.
The PIEZO CHIRPER” chirps 3 times, and the exterior lights flash 3 times, rEMOTE CONTROL is programmed, the system will not work with any REMOTE CONTROL, to activate VALET MODE (disable security functions), insert the key into the ignition switch, and turn it to ON” ( not ACC”).
Using REMOTE CONTROL, press and hold both buttons (at the same time) over 2, –YOU MUST PERFORM THE NEXT STEPS WITHIN 30 SECONDS–, steps, the previous operation mode will remain unchanged, nOTE: This procedure is not necessary if the vehicle is equipped with RS3000 Plus.
Toyota Models