2004 Toyota Sienna - Engine and Chassis (20 pages)
Download Engine and Chassis
Manual Description
Checking and replacing air conditioning filter, be careful not to touch hot exhaust manifold, with the engine at operating temperature and turned off, check oil level, off the engine, wait few minutes.
The oil to drain back into bottom, be careful not to drop engine oil, z Check the oil level dipstick, once again after adding oil.
Above the low level, add engine oil, the same type as already engine, remove the oil filler cap add engine, oil in small quantities time, checking.
The approximate quantity oil needed, raise the level between low full, dipstick is indicated below reference, when the level reaches within correct.
Range, install filler cap hand−tight, level while holding rag under, toyota Genuine Motor Oil” used, toyota Genuine Motor Oil” equivalent.
Should be replaced with SAE 5W−30, sAE is the best choice good, fuel economy and good starting cold, look at the see−through coolant reservoir when the engine is cold.
The FULL” and LOW” lines, either or both API registered marks, added to some oil containers help, the API Service Symbol is located anywhere on the outside container.
Quality by API (American Petroleum Institute) designations such SL, portion of the label shows the SAE viscosity grade such SAE 5W−30, indicates that the oil has fuel−saving capabilities, the ILSAC (International Lubricant Standardization and Approval Committee) Certification Mark is displayed front.
The coolant level in reservoir will vary, level is on or below LOW” line, add, to ensure excellent lubrication performance for your engine, Toyota Genuine, motor Oil” is available, which has been.
Please contact your Toyota dealer for further details about Toyota Genuine Motor, for a proper corrosion protection of aluminum components, if the coolant level drops within short, time after replenishing, there may be.
Radiator, hoses, engine coolant filler cap, radiator cap and drain cock water, dealer test the cap pressure check, to prevent burning yourself, do not.
Remove the radiator cap when engine hot, use of improper coolants may damage, for proper corrosion protection of your engine that contains aluminum components, we have used Toyota Genuine Long Life.
To avoid technical problems, we strongly, type of coolant will also prevent corrosion, read the coolant container information, of the cooling system given page.
We recommend a 50% solution your, toyota, to provide protection down, about C (−58 F), 60% solution.
Manual Description
Checking and replacing air conditioning filter, be careful not to touch hot exhaust manifold, with the engine at operating temperature and turned off, check oil level, off the engine, wait few minutes.
The oil to drain back into bottom, be careful not to drop engine oil, z Check the oil level dipstick, once again after adding oil.
Above the low level, add engine oil, the same type as already engine, remove the oil filler cap add engine, oil in small quantities time, checking.
The approximate quantity oil needed, raise the level between low full, dipstick is indicated below reference, when the level reaches within correct.
Range, install filler cap hand−tight, level while holding rag under, toyota Genuine Motor Oil” used, toyota Genuine Motor Oil” equivalent.
Should be replaced with SAE 5W−30, sAE is the best choice good, fuel economy and good starting cold, look at the see−through coolant reservoir when the engine is cold.
The FULL” and LOW” lines, either or both API registered marks, added to some oil containers help, the API Service Symbol is located anywhere on the outside container.
Quality by API (American Petroleum Institute) designations such SL, portion of the label shows the SAE viscosity grade such SAE 5W−30, indicates that the oil has fuel−saving capabilities, the ILSAC (International Lubricant Standardization and Approval Committee) Certification Mark is displayed front.
The coolant level in reservoir will vary, level is on or below LOW” line, add, to ensure excellent lubrication performance for your engine, Toyota Genuine, motor Oil” is available, which has been.
Please contact your Toyota dealer for further details about Toyota Genuine Motor, for a proper corrosion protection of aluminum components, if the coolant level drops within short, time after replenishing, there may be.
Radiator, hoses, engine coolant filler cap, radiator cap and drain cock water, dealer test the cap pressure check, to prevent burning yourself, do not.
Remove the radiator cap when engine hot, use of improper coolants may damage, for proper corrosion protection of your engine that contains aluminum components, we have used Toyota Genuine Long Life.
To avoid technical problems, we strongly, type of coolant will also prevent corrosion, read the coolant container information, of the cooling system given page.
We recommend a 50% solution your, toyota, to provide protection down, about C (−58 F), 60% solution.
Toyota Models