Download Do-It-Yourself Maintenance
Manual DescriptionIf you perform maintenance yourself, be sure follow correct, procedures as given these sections, zerex G 48” Glysantin G 48”, the dilution ratio both Zerex.
G and Glysantin G 48”, level is on or below L” line, improper filling can lead to traction battery system damage, fuse with same amperage rating.
Bulb with same number and wattage rating original, toyota Super Long Life Coolant”, glycol based non-silicate, nonamine, non-nitrite non-borate, the motor compartment contains many mechanisms and fluids that may move.
Suddenly, become hot, or become electrically energized, serious injury, observe following precautions, ● Make sure that the indicator on the POWER” switch READY”, ● Keep hands, clothing and tools away moving fans.
Right after driving as they may be hot, ● Do not leave anything that may burn easily, such as paper rags, ● Do not smoke, cause sparks or expose an open flame to the 12-volt battery, ● Be extremely cautious when working on the 12-volt battery.
● Take care because brake fluid can harm your hands eyes damage, if fluid gets on your hands or in your eyes, flush affected area with, if you still experience discomfort, see doctor, ● Never touch, disassemble, remove or replace high voltage parts.
That may result in death serious injury, when working near the electric cooling fans radiator grille, be sure the POWER” switch off, with the POWER” switch in ON mode, the electric cooling fans may automatically start to run if the air conditioning is on and/or the coolant temperature high.
Wear safety glasses to prevent flying or falling material, fluid spray, etc, release the lock from the inside of the vehicle open hood, the hood will pop up slightly, hold the hood open by inserting the supporting rod into.
Check that the hood is fully closed locked, and cause an accident, which may result in death serious injury, after installing the support rod into slot, make sure the rod supports the hood securely from falling down your.
Be sure to return the support rod to its clip before closing hood, the hood with the support rod up could cause hood bend, when raising your vehicle with a floor jack, position the jack correctly, before lowering the vehicle onto jack stands, check that jack.
Stands will not contact the traction battery undercover, make sure to observe the following to reduce the possibility of death serious injury, ● Lift up the vehicle using floor jack, such as the one shown illustration.
● When using a floor jack, follow the instructions of manual provided with, ● Always use floor jack and/or automotive jack stands on solid, flat, level, ● Stop the vehicle on level, firm ground, firmly set parking brake, ● Make sure to set the floor jack properly jack point.
Raising the vehicle with an improperly positioned floor jack will damage, the vehicle and may cause the vehicle to fall off floor jack, ● When raising the vehicle, do not place any objects on top underneath, may interfere with traction battery.
● Forcibly using a tire jack may damage, the traction battery cause vehicle, to fall off the jack, resulting death.