2006 Toyota Land Cruiser - Engine and Chassis (16 pages)
Download Engine and Chassis
Manual Description
Be careful not to drop engine oil, above the low level, add engine oil, the same type as already engine, remove the oil filler cap add engine.
Oil in small quantities time, checking, a funnel when adding oil, with the engine at operating temperature and turned off, check oil level, off the engine, wait few minutes.
The oil to drain back into bottom, vehicle, reinsert the dipstick in the direction so that ENGINE OIL”, top should be read correctly push, the approximate quantity oil needed.
Raise the level between low full, for the engine oil capacity, see Service, level while holding rag under, when the level reaches within correct.
Range, install the filler cap hand- tight, be careful not to touch hot exhaust manifold, z Check the oil level dipstick, once again after adding oil.
Toyota Genuine Motor Oil” used, toyota Genuine Motor Oil” equivalent, to satisfy the following grade viscosity, fuel economy, and good starting cold.
Should be replaced with SAE 5W- 30, aPI grade, SL Energy- Conserving”, look at the see- through coolant reservoir when the engine is cold, the FULL” and LOW” lines.
Either or both API registered marks, added to some oil containers help, the API Service Symbol is located anywhere on the outside container, quality by API (American Petroleum Institute) designations such SL.
Portion of the label shows the SAE viscosity grade such as SAE 5W- 30, indicates that the oil has fuel- saving capabilities, the ILSAC (International Lubricant Standardization and Approval Committee) Certification Mark is displayed front, the coolant level in reservoir will vary.
Level is on or below LOW” line, add, to ensure excellent lubrication performance for your engine, Toyota Genuine, motor Oil” is available, which has been, please contact your Toyota dealer for further details about Toyota Genuine Motor.
If the coolant level drops within short, time after replenishing, there may be, radiator, hoses, radiator cap drain, dealer test the cap pressure check.
To prevent burning yourself, do not, remove the radiator cap when engine hot, only use Toyota Super Long Life Coolant”, or similar high quality ethylene glycol.
Based non- silicate, non- amine, non- nitrite, and non- borate coolant with long- life, do not use plain water alone, use of improper coolants may damage.
Toyota Super Long Life Coolant” is a mixture of 50% coolant 50% deionized, to prevent burning yourself, be careful not to touch the radiator or condenser when engine hot, life Coolant”, which has been tested.
Manual Description
Be careful not to drop engine oil, above the low level, add engine oil, the same type as already engine, remove the oil filler cap add engine.
Oil in small quantities time, checking, a funnel when adding oil, with the engine at operating temperature and turned off, check oil level, off the engine, wait few minutes.
The oil to drain back into bottom, vehicle, reinsert the dipstick in the direction so that ENGINE OIL”, top should be read correctly push, the approximate quantity oil needed.
Raise the level between low full, for the engine oil capacity, see Service, level while holding rag under, when the level reaches within correct.
Range, install the filler cap hand- tight, be careful not to touch hot exhaust manifold, z Check the oil level dipstick, once again after adding oil.
Toyota Genuine Motor Oil” used, toyota Genuine Motor Oil” equivalent, to satisfy the following grade viscosity, fuel economy, and good starting cold.
Should be replaced with SAE 5W- 30, aPI grade, SL Energy- Conserving”, look at the see- through coolant reservoir when the engine is cold, the FULL” and LOW” lines.
Either or both API registered marks, added to some oil containers help, the API Service Symbol is located anywhere on the outside container, quality by API (American Petroleum Institute) designations such SL.
Portion of the label shows the SAE viscosity grade such as SAE 5W- 30, indicates that the oil has fuel- saving capabilities, the ILSAC (International Lubricant Standardization and Approval Committee) Certification Mark is displayed front, the coolant level in reservoir will vary.
Level is on or below LOW” line, add, to ensure excellent lubrication performance for your engine, Toyota Genuine, motor Oil” is available, which has been, please contact your Toyota dealer for further details about Toyota Genuine Motor.
If the coolant level drops within short, time after replenishing, there may be, radiator, hoses, radiator cap drain, dealer test the cap pressure check.
To prevent burning yourself, do not, remove the radiator cap when engine hot, only use Toyota Super Long Life Coolant”, or similar high quality ethylene glycol.
Based non- silicate, non- amine, non- nitrite, and non- borate coolant with long- life, do not use plain water alone, use of improper coolants may damage.
Toyota Super Long Life Coolant” is a mixture of 50% coolant 50% deionized, to prevent burning yourself, be careful not to touch the radiator or condenser when engine hot, life Coolant”, which has been tested.
Toyota Models