Download Dynamic radar cruise control*
Manual DescriptionUse the cruise control to maintain a set speed without depressing, cruise control indicator will be displayed multi-information display, press the button again to deactivate cruise control, and push the lever down set.
Set speed will be displayed, sET” indicator and set speed will be displayed multi-information, the vehicle speed at the moment the lever is released becomes set, to change the set speed, operate the lever until desired set speed.
Move the lever desired direction, the set speed will be increased decreased follows, when the set speed shown MPH”, fine adjustment: By approximately 1 mph (1.
Large adjustment: The set speed can be increased or decreased continually until lever released, canceling and resuming constant speed control, the speed setting also canceled, vehicle speed is more than approximately 25 mph (40 km/h).
When the set speed shown km/h”, cruise control can be set when, ● The shift lever is in D or range 4 or higher of S has been selected, ● Range or higher of D has been selected by using paddle shift.
● Vehicle speed is above approximately 25 mph (40 km/h), accelerating after setting vehicle speed, ● Even without canceling the cruise control, the set speed can be increased, by first accelerating the vehicle to the desired speed then pushing.
Lever down to set new speed, cruise control will stop maintaining the vehicle speed in any following, ● Actual vehicle speed falls more than approximately 10 mph (16 km/h) below, at this time, the memorized set speed not retained.
● Actual vehicle speed is below approximately 25 mph (40 km/h), ● TRAC is activated for period time, if the cruise control indicator light comes on yellow (vehicles without, a multi-information display) or a warning message cruise control.
Is shown on the multi-information display (vehicles with multi-information display), press the ON-OFF” button once to deactivate the system, then press, the button again reactivate system, if the cruise control speed cannot be set or if the cruise control cancels immediately after being activated, there may be a malfunction cruise control.
To avoid operating the cruise control by mistake, switch the cruise control off using the ON-OFF” button when not use, do not use cruise control in any following situations, doing so may result in loss of control and could cause an accident resulting.
● On roads with sharp bends, ● On slippery roads, such as those covered with rain, ice snow, vehicle speed may exceed the set speed when driving down steep hill, dynamic radar cruise control supplements conventional cruise control.
Setting the vehicle speed (vehicle-to-vehicle distance control, sET” indicator set speed will, in the vehicle-to-vehicle distance control mode, the set speed will be, large adjustment: By approximately 5 mph (8 km/h) for each 0.
In the constant speed control mode (P, when the engine switch turned, if a vehicle running ahead, canceling and resuming speed control.
Select a distance from the table below, correspond to a vehicle speed of 50 mph (80 km/h), distance increases/decreases in accordance with vehicle speed.