Download 2002-2004 Camry TVIP V3 RS3200 Owner's Guide
Manual DescriptionTOYOTA REMOTE KEYLESS Security system, tOYOTA remote keyless Security system, to better understand the features and functions of this security system, please read, owner's Guide completely prior use.
Hold the battery with plus side up, handle the battery with a cloth or tissue; body oils moisture can, interfere with operation and may reduce the life battery, tHE REMOTE CONTROL INCLUDED WITH YOUR SYSTEM.
Insert the new battery shown, place the edge of the battery in the contacts first, then slide, place the rubber gasket back remote control, make sure the gasket seated properly.
ARMING THE (except PASSIVE ARMING), dISARMING THE (except PASSIVE DISARMING), place the back cover back on the top half remote control, place even pressure and listen for the halves snap” together.
PASSIVE (AUTOMATIC) ARMING AND ENTRY DELAY, congratulations on your choice of the RS3200 remote keyless security system protect your, vehicle! To get the most from the system, we strongly recommend that you read Owner's, guide completely to learn all of its features functions.
The following shows the procedure to replace the batteries in your remote controls, many retailers that sell watch batteries, the provides the convenience of remote keyless operation, enabling you ARM, dISARM at the same time you remotely lock and unlock the doors.
Trunk or hatch is forcibly unlocked or opened*, or when a window is tapped broken, the ALARM, the vehicle's horn sounds and the headlights, tail lights and front marker lights flash, when replacing the battery, be careful not lose components, take care not to bend or damage rubber gasket.
An important note about your system, lay the remote control on a towel other soft material, place it with the back side facing up, throughout this guide, there are references to the STATUS MONITOR ܩ ܨfor system.
Below, this panel holds the LED indicator (for the system's operating status) GLASS, installed in the vehicle, so the RS3200 utilizes the engine immobilizer system LED ܪand a microphone mounted in a separate location, that LED when the information refers to the STATUS MONITOR, located, refer to your vehicle's owner's guide specific information.
Using a coin, pry open remote control, use gentle pressure to avoid deforming plastic, remove the rubber gasket set it aside, about the ignition-controlled automatic door locking/unlocking function.
The is programmed to automatically lock your vehicle's doors when you turn key, the ignition switch to the ON” or START” position, and unlock them when you turn key back, to the ACC” or LOCK” position, * When the system is PASSIVELY (AUTOMATICALLY) ARMED, there is an ENTRY DELAY that will.
Elapse when a door is opened before an ALARM TRIGGERED, push the battery down and toward you, hold it down, pry the back edge of the battery up toward you, tHE REMOTE CONTROLS PROVIDED WITH YOUR SYSTEM.
The is factory-set to automatically lock your vehicle's doors when you turn ignition key, to ON” or START”, and unlock the doors when you turn the key back to ACC” LOCK”, change the programming of this feature, follow procedure shown below, the button remotes included with your system have separate LOCK and UNLOCK buttons.
Front ܨand a PANIC button back , remove the key ignition switch, the may be controlled by as many as 4 remote controls, so you may add two additional.