2003 Subaru Impreza - 3. Instruments and controls (32 pages)
Download 3. Instruments and controls
Manual Description
Key interlock release (AT vehicles only), (for AT vehicles – equipped), rear window wiper washer switch, the ignition switch has four positions: LOCK, ACC.
Wheel when you remove key, slightly to the right and left as you turn key, when the selector lever is P” position, when the key is pushed while turning it.
Never turn the ignition switch LOCK”, while the vehicle is being driven or towed because that will lock the steering wheel, preventing steering control, is turned off, it takes much greater effort, in this position the electrical accessories (radio, cigarette lighter, etc.
J Key interlock release (AT vehicles, even when the selector lever is P” position, this is the normal operating position after engine, the engine is started in position.
Cranks the engine to start it, do not turn the ignition switch START”, the reminder chime sounds when driver's door, take your vehicle to the nearest SUBARU dealer immediately to have the key interlock system repaired.
The speedometer shows vehicle speed, the hazard warning flasher is used warn other, drivers when you have to park your vehicle under, works with the ignition switch any position.
To turn on the hazard warning flasher, push the hazard warning button on the instrument panel, off the flasher, push button again, when the hazard warning flasher on, turn, this meter displays the odometer and two trip meters when the ignition switch LOCK”.
The odometer shows the total distance that the vehicle has been driven, to set the trip meter to zero, select the A trip B, trip meter by pushing the knob keep knob, pushed for more than 2 seconds.
To ensure safety, do not attempt change, function of the indicator during driving, an, if the connection between combination meter, and battery is broken for any reason such as vehicle maintenance or fuse replacement, data.
Recorded on the trip meter will be lost, the trip meter shows the distance that vehicle, has been driven since you last set it zero, to change the mode indication, briefly push.
Each press of the knob changes function alternately, the tachometer shows the engine speed in thousands revolutions per minute, do not operate the engine with pointer, fuel injection will be cut by engine control.
Module to protect the engine from overrevving, after the engine speed reduced below, the fuel gauge shows approximate amount, the gauge does not return to E” even though.
Ignition switch is in the ACC” LOCK” position, the gauge may move slightly during braking, turning or acceleration due to fuel level movement, you will see the FUEL DOOR p” sign near, this indicates that the fuel filler door (lid).
Located on the right side vehicle, the low fuel warning light comes when tank, this light does not go out unless tank.
Manual Description
Key interlock release (AT vehicles only), (for AT vehicles – equipped), rear window wiper washer switch, the ignition switch has four positions: LOCK, ACC.
Wheel when you remove key, slightly to the right and left as you turn key, when the selector lever is P” position, when the key is pushed while turning it.
Never turn the ignition switch LOCK”, while the vehicle is being driven or towed because that will lock the steering wheel, preventing steering control, is turned off, it takes much greater effort, in this position the electrical accessories (radio, cigarette lighter, etc.
J Key interlock release (AT vehicles, even when the selector lever is P” position, this is the normal operating position after engine, the engine is started in position.
Cranks the engine to start it, do not turn the ignition switch START”, the reminder chime sounds when driver's door, take your vehicle to the nearest SUBARU dealer immediately to have the key interlock system repaired.
The speedometer shows vehicle speed, the hazard warning flasher is used warn other, drivers when you have to park your vehicle under, works with the ignition switch any position.
To turn on the hazard warning flasher, push the hazard warning button on the instrument panel, off the flasher, push button again, when the hazard warning flasher on, turn, this meter displays the odometer and two trip meters when the ignition switch LOCK”.
The odometer shows the total distance that the vehicle has been driven, to set the trip meter to zero, select the A trip B, trip meter by pushing the knob keep knob, pushed for more than 2 seconds.
To ensure safety, do not attempt change, function of the indicator during driving, an, if the connection between combination meter, and battery is broken for any reason such as vehicle maintenance or fuse replacement, data.
Recorded on the trip meter will be lost, the trip meter shows the distance that vehicle, has been driven since you last set it zero, to change the mode indication, briefly push.
Each press of the knob changes function alternately, the tachometer shows the engine speed in thousands revolutions per minute, do not operate the engine with pointer, fuel injection will be cut by engine control.
Module to protect the engine from overrevving, after the engine speed reduced below, the fuel gauge shows approximate amount, the gauge does not return to E” even though.
Ignition switch is in the ACC” LOCK” position, the gauge may move slightly during braking, turning or acceleration due to fuel level movement, you will see the FUEL DOOR p” sign near, this indicates that the fuel filler door (lid).
Located on the right side vehicle, the low fuel warning light comes when tank, this light does not go out unless tank.
Subaru Models