2003 Subaru Baja - 9. In case of emergency (28 pages)
Download 9. In case of emergency
Manual Description
If you park your vehicle an emergency, moonroof — if the moonroof cannot be closed, the hazard warning flasher should be used in day or night warn other, drivers when you have to park your vehicle under emergency conditions.
The hazard warning flasher can be activated regardless ignition, turn on the hazard warning by pushing hazard warning flasher, when the hazard warning flasher is on, the turn signals do not work, the jack supplied with the vehicle is designed only changing tire.
Before using the jack, see the Flat tire” section chapter, the jack and tool bag are located in the left side rear quarter pocket, at the back side rear seatback, a wheel nut wrench, jack drive tube, tire holding rod, tire holding.
Retainer, screwdriver and moonroof wrench are included tool, b Removing jack tool bag, gain access to the rear quarter pockets both sides, d Make sure the jack is well lubricated before using it.
Jack with the jack holding screw by turning it clockwise, confirm no looseness exists after securing jack, may cause a rattle while vehicle moving, after the jack and the tool bag have been restored rear.
Quarter pocket, make sure that the rear seatback has been, locking knobs no longer visible, the spare tire is stored in the spare tire holder located under rear, the spare tire holder has a hoist mechanism that can lower raise.
Before using the temporary spare tire, see Temporary spare tire”, section in this Chapter instructions precautions, and tools” section in this Chapter its storage location, pull up the RELEASE” portion of the cap when removing it.
Wrench until the temporary spare tire is on ground with enough, cable slack to allow you to pull it out under vehicle, do not put your fingers into the center hole temporary, spare tire while you pulling it out, because they might be pinched.
In between the wheel retainer, must be wound up completely by turning the hoist nut shaft clockwise, until you hear a clicking sound, make certain that there is no longer any slack present.
D When using spare tire hoist, after the temporary spare tire is removed cable, wind, the cable up completely until the retainer at end cable sits, against the underside of the vehicle.
Retracted fully could result in damage to adjacent under floor, parts and lead serious accident, d The spare tire holder is designed to carry only the smaller temporary spare tire, under floor parts and can lead serious accident.
When using spare tire hoist, nut wrench to loosen the cable sufficiently enough allow cable, end retainer go through center hole of temporary spare tire, (with the outside of tire facing up).
Wind the cable up completely until you hear few clicking sounds, confirm that the temporary spare tire holding cable has been wound, up completely by shaking temporary tire, if the temporary spare tire is not stored securely, it could damage.
Adjacent areas of the vehicle and make an abnormal noise, jack and tool bag their storage locations, j Using temporary spare tire.
Manual Description
If you park your vehicle an emergency, moonroof — if the moonroof cannot be closed, the hazard warning flasher should be used in day or night warn other, drivers when you have to park your vehicle under emergency conditions.
The hazard warning flasher can be activated regardless ignition, turn on the hazard warning by pushing hazard warning flasher, when the hazard warning flasher is on, the turn signals do not work, the jack supplied with the vehicle is designed only changing tire.
Before using the jack, see the Flat tire” section chapter, the jack and tool bag are located in the left side rear quarter pocket, at the back side rear seatback, a wheel nut wrench, jack drive tube, tire holding rod, tire holding.
Retainer, screwdriver and moonroof wrench are included tool, b Removing jack tool bag, gain access to the rear quarter pockets both sides, d Make sure the jack is well lubricated before using it.
Jack with the jack holding screw by turning it clockwise, confirm no looseness exists after securing jack, may cause a rattle while vehicle moving, after the jack and the tool bag have been restored rear.
Quarter pocket, make sure that the rear seatback has been, locking knobs no longer visible, the spare tire is stored in the spare tire holder located under rear, the spare tire holder has a hoist mechanism that can lower raise.
Before using the temporary spare tire, see Temporary spare tire”, section in this Chapter instructions precautions, and tools” section in this Chapter its storage location, pull up the RELEASE” portion of the cap when removing it.
Wrench until the temporary spare tire is on ground with enough, cable slack to allow you to pull it out under vehicle, do not put your fingers into the center hole temporary, spare tire while you pulling it out, because they might be pinched.
In between the wheel retainer, must be wound up completely by turning the hoist nut shaft clockwise, until you hear a clicking sound, make certain that there is no longer any slack present.
D When using spare tire hoist, after the temporary spare tire is removed cable, wind, the cable up completely until the retainer at end cable sits, against the underside of the vehicle.
Retracted fully could result in damage to adjacent under floor, parts and lead serious accident, d The spare tire holder is designed to carry only the smaller temporary spare tire, under floor parts and can lead serious accident.
When using spare tire hoist, nut wrench to loosen the cable sufficiently enough allow cable, end retainer go through center hole of temporary spare tire, (with the outside of tire facing up).
Wind the cable up completely until you hear few clicking sounds, confirm that the temporary spare tire holding cable has been wound, up completely by shaking temporary tire, if the temporary spare tire is not stored securely, it could damage.
Adjacent areas of the vehicle and make an abnormal noise, jack and tool bag their storage locations, j Using temporary spare tire.
Subaru Models