2007 Nissan Versa - Supplemental Restraint System (Section SRS) (58 pages)
Download Supplemental Restraint System (Section SRS)
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Passenger Air Bag Module 5, front Seat Belt Pre-tensioner with Load Limiter 6.
FOR QUICK AND ACCURATE REPAIR 9, wiring Diagram — SRS — 13, hOW TO CHANGE BETWEEN SELF-DIAGNOSIS MODE AND USER MODE WITH CONSULTII 19, hOW TO ERASE SELF-DIAGNOSIS RESULTS 20.
HOW TO CHANGE BETWEEN USER MODE, hOW TO ERASE SELF-DIAGNOSIS RESULTS 21, wARNING LAMP FLASH CODE CHART 35, trouble Diagnosis: AIR BAG” Warning Lamp Does.
FRONT PASSENGER AIR BAG MODULE 46, sIDE CURTAIN AIR BAG MODULE 47, sIDE AIR BAG (SATELLITE) SENSOR 50, oCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT 53.
WHEN SRS IS ACTIVATED IN THE SIDE OR, wHEN SRS IS NOT ACTIVATED IN THE SIDE, sRS INSPECTION (FOR SIDE AND ROLLOVER, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT.
The Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted.
Information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
Precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service, do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt.
The air bag diagnosis sensor unit must always be installed with the arrow mark ⇐” pointing toward, front of the vehicle for proper operation, rust before installation replace required, the spiral cable must be aligned with the neutral position since its rotations are limited.
Turn steering wheel or column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.
Do not reuse center pillar upper garnish removed, replace control unit and passenger front seat cushion an assembly, the collision modes for which supplemental restraint systems are activated are different among the SRS systems, sRS configurations for some collision modes follows.
Front LH side air bag module, front RH side air bag module, lH side curtain air bag module, rH side curtain air bag module.
The driver air bag module is dual stage and located steering, the front passenger air bag module is located behind instrument, panel assembly (mounted to the steering member), refer to "Occupant Classification System (OCS)" more.
Front side air bag modules are built into the front seatback assemblies, side curtain air bag modules are located above the vehicle headlining and run from the front to the rear of vehicle, side curtain air bags are equipped with labels shown.
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Passenger Air Bag Module 5, front Seat Belt Pre-tensioner with Load Limiter 6.
FOR QUICK AND ACCURATE REPAIR 9, wiring Diagram — SRS — 13, hOW TO CHANGE BETWEEN SELF-DIAGNOSIS MODE AND USER MODE WITH CONSULTII 19, hOW TO ERASE SELF-DIAGNOSIS RESULTS 20.
HOW TO CHANGE BETWEEN USER MODE, hOW TO ERASE SELF-DIAGNOSIS RESULTS 21, wARNING LAMP FLASH CODE CHART 35, trouble Diagnosis: AIR BAG” Warning Lamp Does.
FRONT PASSENGER AIR BAG MODULE 46, sIDE CURTAIN AIR BAG MODULE 47, sIDE AIR BAG (SATELLITE) SENSOR 50, oCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT 53.
WHEN SRS IS ACTIVATED IN THE SIDE OR, wHEN SRS IS NOT ACTIVATED IN THE SIDE, sRS INSPECTION (FOR SIDE AND ROLLOVER, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT.
The Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted.
Information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
Precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service, do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt.
The air bag diagnosis sensor unit must always be installed with the arrow mark ⇐” pointing toward, front of the vehicle for proper operation, rust before installation replace required, the spiral cable must be aligned with the neutral position since its rotations are limited.
Turn steering wheel or column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.
Do not reuse center pillar upper garnish removed, replace control unit and passenger front seat cushion an assembly, the collision modes for which supplemental restraint systems are activated are different among the SRS systems, sRS configurations for some collision modes follows.
Front LH side air bag module, front RH side air bag module, lH side curtain air bag module, rH side curtain air bag module.
The driver air bag module is dual stage and located steering, the front passenger air bag module is located behind instrument, panel assembly (mounted to the steering member), refer to "Occupant Classification System (OCS)" more.
Front side air bag modules are built into the front seatback assemblies, side curtain air bag modules are located above the vehicle headlining and run from the front to the rear of vehicle, side curtain air bags are equipped with labels shown.
Nissan Models