2008 Nissan Sentra - Supplemental Restraint System (Section SRS) (48 pages)

Model: 2008 Nissan Sentra
File size: 1.33 MB
Pages: 48 pages



Download Supplemental Restraint System (Section SRS)

Manual Description
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 2, precaution for SRS "AIR BAG" "SEAT BELT, front Passenger Air Bag Module 5, front Seat Belt Pre-tensioner with Load Limiter 6.

Trouble Diagnosis: "AIR BAG" Warning Lamp, fRONT PASSENGER AIR BAG MODULE 34, sIDE CURTAIN AIR BAG MODULE 38, sIDE AIR BAG (SATELLITE) SENSOR 41.

Precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front.

Air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, the event of a collision which would result in air bag inflation, all maintenance must be performed by.

Improper maintenance, including incorrect removal and installation of the SRS, can lead personal, injury caused by unintentional activation of the system, precaution for SRS "AIR BAG" and "SEAT BELT PRE-TENSIONER" Service, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes.

For approximately minutes after the cables are removed, it is still possible for the air bag and seat belt pretensioner to deploy, of the vehicle for proper operation, the spiral cable must be aligned with the neutral position since its rotations are limited, turn steering wheel or column after removal steering gear.

Handle air bag module carefully, facing upward and seat mounted front side air bag module standing with the stud bolt side facing down, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.

Replace control unit and passenger front seat cushion an assembly, the actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, air bag lock master key set, removing and installing air bag lock.

The collision modes for which supplemental restraint systems are activated are different among the SRS systems, sRS configurations for some collision modes follows, front LH side air bag module, front RH side air bag module.

LH side curtain air bag module, rH side curtain air bag module, the driver air bag module is dual stage and located steering, the front passenger air bag module is located behind instrument.

Front side air bag modules are built into the front seatback assemblies, side curtain air bag modules are located above the vehicle headlining and run from the front to the rear of vehicle, side curtain air bags are equipped with labels shown, front Seat Belt Pre-tensioner with Load Limiter.

The seat belt pre-tensioner system with load limiter installed, both the driver's seat and the front passenger's seat, simultaneously with the SRS air bag system in the event frontal, collision with an impact exceeding specified level.

When the frontal collision with an impact exceeding specified level, occurs, seat belt slack resulting from clothing other factors, immediately taken up by the pre-tensioner, when passengers in a vehicle are thrown forward collision.

The restraining force of the seat belt exceeds specified level, load limiter permits the specified extension of the seat belt by, twisting of the ELR shaft, and a relaxation of chest-area seat belt.