2004 Nissan Sentra - Body Control System (Section BCS) (12 pages)
Download Body Control System (Section BCS)
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 2, wiring Diagrams Trouble Diagnosis 2, smart Entrance Control Unit Inspection Table 9, description (Without Power Door Locks) 10.
Schematic (Without Power Door Locks) 11, time Control Unit Inspection Table (Without Power, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
When you read wiring diagrams, refer following, "How to Read Wiring Diagrams", when you perform trouble diagnosis, refer following, "HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES".
"How to Perform Efficient Diagnosis an Electrical Incident", check for any Service bulletins before servicing vehicle, the smart entrance control unit totally controls the following body electrical system operations, rear window defogger door mirror defogger.
The lamps turn off automatically when the interior lamp, map lamp or/and vanity lamps illuminated with, the ON position approximately 10 minutes, after lamps are turned off by the battery saver system, the lamps illuminate again when, key is inserted into or removed from ignition key cylinder.
Rear window defogger and door mirror defogger are turned off approximately 15 minutes after the rear window defogger switch turned on, door lock and unlock switch LH RH, warning chime (located smart entrance, trunk lid key cylinder switch (unlock).
Battery saver control interior lamp/map lamp/vanity, main power window door lock/unlock switch, for diagnostic item in each control system, refer to the relevant pages each system, input/output data in the smart entrance control unit can be read.
Diagnostic Test Mode in which CONSULT-II drives some systems, apart from the smart entrance control unit, wORK SUPPORT THEFT WAR ALM, the recorded trigger signal when vehicle security system was.
WORK SUPPORT MULTI REMOTE ENT, iD code of keyfob can be registered erased, if CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be, detected in self-diagnosis depending on control unit which carry out CAN communication.
Perform each diagnostic item according DIAGNOSTIC, smart Entrance Control Unit Inspection Table, when panic alarm is operated using Keyfob when alarm, when doors locked using Keyfob.
When interior lamp is operated using Keyfob (Lamp switch, battery saver does not operate → Operate, when doors are locked using Keyfob with horn chirp mode, unfasten → Fasten (Ignition key ON” position).
Key inserted → Key removed IGN key cylinder, ignition key is in ON” "START" position, air control (Rear window defogger switch), the time control unit totally controls the following body electrical system operations.
Warning chime (located time control unit), time Control Unit Inspection Table (Without Power Door Locks)...
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 2, wiring Diagrams Trouble Diagnosis 2, smart Entrance Control Unit Inspection Table 9, description (Without Power Door Locks) 10.
Schematic (Without Power Door Locks) 11, time Control Unit Inspection Table (Without Power, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
When you read wiring diagrams, refer following, "How to Read Wiring Diagrams", when you perform trouble diagnosis, refer following, "HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES".
"How to Perform Efficient Diagnosis an Electrical Incident", check for any Service bulletins before servicing vehicle, the smart entrance control unit totally controls the following body electrical system operations, rear window defogger door mirror defogger.
The lamps turn off automatically when the interior lamp, map lamp or/and vanity lamps illuminated with, the ON position approximately 10 minutes, after lamps are turned off by the battery saver system, the lamps illuminate again when, key is inserted into or removed from ignition key cylinder.
Rear window defogger and door mirror defogger are turned off approximately 15 minutes after the rear window defogger switch turned on, door lock and unlock switch LH RH, warning chime (located smart entrance, trunk lid key cylinder switch (unlock).
Battery saver control interior lamp/map lamp/vanity, main power window door lock/unlock switch, for diagnostic item in each control system, refer to the relevant pages each system, input/output data in the smart entrance control unit can be read.
Diagnostic Test Mode in which CONSULT-II drives some systems, apart from the smart entrance control unit, wORK SUPPORT THEFT WAR ALM, the recorded trigger signal when vehicle security system was.
WORK SUPPORT MULTI REMOTE ENT, iD code of keyfob can be registered erased, if CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be, detected in self-diagnosis depending on control unit which carry out CAN communication.
Perform each diagnostic item according DIAGNOSTIC, smart Entrance Control Unit Inspection Table, when panic alarm is operated using Keyfob when alarm, when doors locked using Keyfob.
When interior lamp is operated using Keyfob (Lamp switch, battery saver does not operate → Operate, when doors are locked using Keyfob with horn chirp mode, unfasten → Fasten (Ignition key ON” position).
Key inserted → Key removed IGN key cylinder, ignition key is in ON” "START" position, air control (Rear window defogger switch), the time control unit totally controls the following body electrical system operations.
Warning chime (located time control unit), time Control Unit Inspection Table (Without Power Door Locks)...
Nissan Models