2014 Nissan Murano - Emission Control System (Section EC) (536 pages)

Model: 2014 Nissan Murano
File size: 6.18 MB
Pages: 536 pages



Download Emission Control System (Section EC)

Manual Description
BASIC INSPECTION : Special Repair Requirement 13, cONTROL UNIT : Special Repair Requirement 16, iDLE SPEED : Special Repair Requirement 18, iGNITION TIMING : Special Repair Requirement 18.

VIN REGISTRATION : Special Repair Requirement 19, lEARNING : Special Repair Requirement 19, tHROTTLE VALVE CLOSED POSITION LEARNING 19, iDLE AIR VOLUME LEARNING : Description20.

IDLE AIR VOLUME LEARNING : Special Repair, hOW TO ERASE PERMANENT DTC 29, fUEL FILLER CAP WARNING SYSTEM 108, oN BOARD DIAGNOSTIC (OBD) SYSTEM 118.

DIAGNOSIS DESCRIPTION : 1st Trip Detection, logic and Two Trip Detection Logic 119, dIAGNOSIS DESCRIPTION : DTC Freeze, dIAGNOSIS DESCRIPTION : Counter System 120.

DIAGNOSIS DESCRIPTION : Driving Pattern 123, dIAGNOSIS DESCRIPTION : Permanent Diagnostic Trouble Code (Permanent DTC) 125, dIAGNOSIS DESCRIPTION : Malfunction Indicator Lamp (MIL) 126, pOWER SUPPLY AND GROUND CIRCUIT 148.

EVAP CONTROL SYSTEM PRESSURE SENSOR 309, eVAP CONTROL SYSTEM PRESSURE SENSOR 313, eVAP CONTROL SYSTEM PRESSURE SENSOR 318, aSCD VEHICLE SPEED SENSOR 389.

VIAS CONTROL SOLENOID VALVE 1, vIAS CONTROL SOLENOID VALVE 2, component Inspection (ASCD Brake Switch) 434, tHROTTLE CONTROL MOTOR RELAY 408.

Component Inspection (Cooling Fan Motor) 439, component Inspection (Cooling Fan Relay) 440, test Value Test Limit 511, component Inspection (Ignition Coil with Power.

ON BOARD REFUELING VAPOR RECOVERY (ORVR) 459, fOR MEXICO : Precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, precautions For Xenon Headlamp Service 525, precaution for Procedure without Cowl Top Cover 525.

Precautions for Removing Battery Terminal 525, on Board Diagnostic (OBD) System Engine, include trip freeze frame data, get the detailed information from the customer about the symptom (the condition environment.

When the incident/malfunction occurred) using the Diagnostic Work Sheet”, ask if the customer requests I/M examination, no Malfunction information, but a request for I/M examination>>GO TO 13, check DTC All DTC Reading”.

Perform the following procedure DTC displayed, record DTC and freeze frame data, with CONSULT: Refer to How to Erase DTC and 1st Trip DTC” EC-129, "CONSULT Function", without CONSULT: Refer to How to Erase Self-diagnostic Results” in EC-126, "On Board Diagnosis.

Study the relationship between the cause detected by DTC and the symptom described by customer, are any symptoms described any DTCs detected, symptom is described, DTC detected>>GO TO 3, symptom is described, DTC is not detected>>GO TO 4.

Symptom is not described, DTC detected>>GO TO 5, try to confirm the symptom described by the customer (except MIL ON), also study the normal operation and fail-safe related to the symptom.