2007 Nissan Murano - Supplemental Restraint System (Section SRS) (60 pages)
Download Supplemental Restraint System (Section SRS)
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Seat Belt Pre-Tensioner with Load Limiter 6, passenger Air Bag Status Condition 7.
Component Parts of Occupant Classification System 7, fOR QUICK AND ACCURATE REPAIR 9, wiring Diagram — SRS — 13, wARNING LAMP FLASH CODE CHART 36.
Trouble Diagnosis: AIR BAG” Warning Lamp Does, fRONT PASSENGER AIR BAG MODULE 47, sIDE CURTAIN AIR BAG MODULE 49, sIDE AIR BAG (SATELLITE) SENSOR 52.
WHEN THE SIDE AIR BAG IS ACTIVATED IN, wHEN SRS IS NOT ACTIVATED IN THE SIDE, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS and SB section Service Manual.
To avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed, precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service.
Do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt, diagnosis sensor unit must always be installed with their arrow marks ⇐” pointing towards front.
The spiral cable must be aligned with the neutral position since its rotations are limited, ing wheel and column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components.
After air bag inflates, the front instrument panel assembly should be replaced damaged, always replace instrument panel pad following front passenger air bag deployment, replace occupant classification system control unit and passenger front seat cushion an assembly, the collision modes for which supplemental restraint systems are activated are different among the SRS systems.
SRS configurations which are activated for some collision modes follows, front LH side air bag module, front RH side air bag module, lH side curtain air bag module.
RH side curtain air bag module, front Seat Belt Pre-Tensioner with Load Limiter, the seat belt pre-tensioner system with load limiter installed, both the driver's seat and the front passenger's seat.
Simultaneously with the SRS air bag system in the event frontal, collision with an impact exceeding specified level, when the frontal collision with an impact exceeding specified level, occurs, seat belt slack resulting from clothing other factors.
Immediately taken up by the pre-tensioner, when passengers in a vehicle are thrown forward collision, the restraining force of the seat belt exceeds specified level, load limiter permits the specified extension of the seat belt by.
Twisting of the ELR shaft, and a relaxation of chest-area seat belt, front side air bag built-in type, the front seatbacks with built-in type side air bag have labels.
Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, front Seat Belt Pre-Tensioner with Load Limiter 6, passenger Air Bag Status Condition 7.
Component Parts of Occupant Classification System 7, fOR QUICK AND ACCURATE REPAIR 9, wiring Diagram — SRS — 13, wARNING LAMP FLASH CODE CHART 36.
Trouble Diagnosis: AIR BAG” Warning Lamp Does, fRONT PASSENGER AIR BAG MODULE 47, sIDE CURTAIN AIR BAG MODULE 49, sIDE AIR BAG (SATELLITE) SENSOR 52.
WHEN THE SIDE AIR BAG IS ACTIVATED IN, wHEN SRS IS NOT ACTIVATED IN THE SIDE, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS and SB section Service Manual.
To avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed, precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service.
Do not use electrical test equipment to check SRS circuits unless instructed to Service Manual, before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt, diagnosis sensor unit must always be installed with their arrow marks ⇐” pointing towards front.
The spiral cable must be aligned with the neutral position since its rotations are limited, ing wheel and column after removal steering gear, side facing upward and seat mounted front side air bag module standing with the stud bolt side facing, conduct self-diagnosis to check entire SRS for proper function after replacing any components.
After air bag inflates, the front instrument panel assembly should be replaced damaged, always replace instrument panel pad following front passenger air bag deployment, replace occupant classification system control unit and passenger front seat cushion an assembly, the collision modes for which supplemental restraint systems are activated are different among the SRS systems.
SRS configurations which are activated for some collision modes follows, front LH side air bag module, front RH side air bag module, lH side curtain air bag module.
RH side curtain air bag module, front Seat Belt Pre-Tensioner with Load Limiter, the seat belt pre-tensioner system with load limiter installed, both the driver's seat and the front passenger's seat.
Simultaneously with the SRS air bag system in the event frontal, collision with an impact exceeding specified level, when the frontal collision with an impact exceeding specified level, occurs, seat belt slack resulting from clothing other factors.
Immediately taken up by the pre-tensioner, when passengers in a vehicle are thrown forward collision, the restraining force of the seat belt exceeds specified level, load limiter permits the specified extension of the seat belt by.
Twisting of the ELR shaft, and a relaxation of chest-area seat belt, front side air bag built-in type, the front seatbacks with built-in type side air bag have labels.
Nissan Models