Download Maintenance (Section MA)
Manual Description(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, dRIVE BELT DEFLECTION AND TENSION 16, changing Positive Crankcase Ventilation (PCV) Filter 23, eNGINE MAINTENANCE AND VG33ER) 24.
DRIVE BELT DEFLECTION AND TENSION 25, checking Clutch Fluid Level Leaks 36, checking Water Entry — For 4X4 Models With M/T 37, checking Brake Fluid Level Leaks 41.
Checking Brake Lines Cables 41, checking Steering Gear Linkage 43, checking Power Steering Fluid Lines 43, fRONT AND REAR AXLE AND SUSPENSION.
Lubricating Locks, Hinges Hood Latches45, checking Seat Belts, Buckles, Retractors, Anchors, precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along.
With a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, equipped with dual stage front air bag modules, the SRS system uses the seat belt switches determine, front air bag deployment, and may only deploy one front air bag, depending on the severity collision, whether the front occupants are belted or unbelted.
The vehicle may be equipped with a passenger air bag deactivation switch, a rear-facing child restraint can be placed, the switch is designed to turn off the passenger air bag so that, rear-facing child restraint can be used in the front passenger seat, enabled and could inflate for certain types of collision.
Up when the passenger air bag is switched OFF, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed.
The vehicle may be equipped with a passenger air bag deactivation switch which can be operated, and could inflate for certain types of collision, passenger air bag deactivation switch is in the same position (ON or OFF) when vehicle, the actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
General maintenance includes those items which should be checked during normal day-to-day operation, checks and inspections themselves or have their NISSAN dealers do them, the maintenance items listed here should be performed from time to time, unless otherwise specified, check the pressure with a gauge at least once a month and always prior.
For damage, cuts excessive wear, when checking the tires, make sure no nuts are missing, check any, tires should be rotated every 12,000 km (7,500 miles), if the vehicle pulls to either side while driving on a straight and level road.
You detect uneven or abnormal tire wear, there may be a need for wheel alignment, clean the windshield on a regular basis, months for cracks or other damage, check for cracks or wear if they do not wipe properly.
Check that all doors and the engine hood operate smoothly as well trunk, when the primary latch released, when driving in areas using road salt or other corrosive materials, check lubrication frequently, make sure that the headlamps, stop lamps, tail lamps, turn signal lamps.
Other lamps are all operating properly and installed securely, the maintenance items listed here should be checked on a regular basis, such as when performing periodic maintenance, cleaning, make sure that all warning lamps and buzzers/chimes operating properly, check that the wipers and washer operate properly and that wipers do not.
Check that the air comes out of the defroster outlets properly sufficient, quantity when operating the heater air conditioner, check that it has the specified play.